Autometer Ultra-Lite Boost Gauge
Here are some pics of my 2 1/16" Autometer Ultra-Lite boost gauge
installed on the A pillar with an Autometer single gauge pod. (I have since replaced it with an Autometer Phantom boost gauge.) The pressure source was tapped into a vacuum line
that attaches to the intake plenum, near the throttle body. The wiring for the light was hooked into the rheostat (must be positive AND negative wires),
so that it will dim with the interior lights. The information for dimming the lights was taken from a post at
3SI.
Pressure Source
The pressure source is the tee that is located on the lower side of both of the following pics; the upper tee is the manual boost controller.
Gauge
Return to the main page